Are you a homeowner in the Pearland, TX area? Is your furnace blowing cold air? We understand the responsibilities of owning a home and how overwhelming it can be when your furnace stops working during the winter months.
As you notice your heat not working, you’re probably jumping to conclusions. You’re wondering how expensive it will be to fix your furnace or how much a new one will cost. Well, we’re here to tell you it might be an easier (and cheaper) fix than what you might think.
If you’re ready to heat your house up, then keep reading below to see what you should do when your furnace is blowing out cold air.
Check Your Thermostat
Many homeowners in Pearland, TX, don’t realize their thermostat can cause furnace problems. That is, having cold air blowing out of vents when the heat is on. Your thermostat is the brain of the operation. Your furnace won’t turn on or shut off until your thermostat communicates that.
If you have your thermostat set correctly and you still have no heat in your house, it might be time to replace it. Thermostat installation is one of many services we offer in your area. We’d be happy to come out and see if that’s what’s causing your heating issue.
Check Your Air Filter
We have all, at some point in our lives, forgotten to replace the air filter when cold weather strikes. It’s an easy chore to let slip through the cracks when you’re in a hurry to warm your home up. However, when you don’t routinely clean or replace your air filters, they will become blocked. This will cause your furnace to either work too hard or not work at all.
Be sure to replace your air filter and see if your furnace starts blowing out warm air again. It’s a good rule of thumb to replace your air filter every 90 days.
Check Your Pilot Light
There’s a good chance your pilot light went out, causing your furnace to blow out cold air. The furnace cannot heat up unless the pilot light is on. Remove your furnace door and see if there is a blue flame.
If you don’t see a flame, that means your pilot light is out. With 5 simple steps, you can try to relight your pilot light yourself. If you happen to see a yellow flame, that means your burners are dirty, and they need to be cleaned.
Is Your Furnace Blowing Cold Air? Contact Us Today
Are you still wondering, “why is my heat blowing cold air” after trying the above suggestions? If so, it’s probably time to call out the professionals. We at Dalton Air Conditioning & Heating have been serving Pearland, TX residents for decades.
We also proudly serve the Friendswood, TX area and the West University, TX community. Contact us today and we’ll gladly take a closer look at your heater. If your furnace is blowing cold air, then we want to get that resolved as soon as possible.
We have been exceeding customer expectations since 1972 and look forward to helping you with your heating repair needs.
